Product Profile of Ductility Testing Machine with Stainless Steel Bath
Ductility Testing Machine with Stainless Steel Bath is used for determining the ductility of bituminous materials by measuring the elongation before breaking when two ends of a briquette specimen are pulled apart at a speed of 50mm/min + 2.5mm/min at temperature of 27degree C + 0.5 degree C. The Ductility Testing Machine is designed with stainless steel bath, temperature controller and immersion electric heater. Ductility Testing Machine with Stainless Steel Bath comes with electric motor with gear mechanism, stainless steel scale and pointer and control panel.
Key Features of Ductility Testing Machine with Stainless Steel Bath
- Consists of water bath with a thermostatic heater and a circulating pump to maintain uniform water temperature.
- One half of the briquette moulds is fixed in a fixed plate in the water bath, the other half of the briquette mould is fixed to a carrier which slides over a rotating threaded shaft with a clutch.
- The motor and gears to rotate the shaft are housed in a cabinet fixed above the other end of the both.
- A pointer fixed to the carrier moves over. a scale graduated from 0-110 cm x 1mm fixed on the bath with "0" [Zero] of the scale towards the fixed plates side.
- The rotating shaft has 2 speeds of travel for the bracket, 5 cm/min. and 1cm/min. selected by a clutch.
- Water bath inside is of Stainless steel with insulation and a water drain.
- A heater with thermostatic control is fitted inside the water bath.
- Control switches for motor, stirrer, heater and indicator lamps are fitted to a control panel located at a convenient place on the water bath.
- Complete with three briquette moulds and one base plate.
- Working on 230 Volts, single phase, 50 cycles, AC.
