Product Profile of Armoring Machines Without Back Twist
Saraswati Engineering Works offers Armoring Machines without Back Twist. Armoring Machines without Back Twist are used for armoring of XLPE HT and LT Power Cables, Control, Special Instrumentation, Rubber Cables, etc. The features of the Armoring Machines without Back Twist are:
- Without Back Twist for GI Strip Armor Carriage, Cradles are rectangular shaped fabricated fastened between discs supported on bearings at both ends. Discs are fitted on hollow shaft tube with under roller or without under roller carriage with heavy duty pedestal bearing to support the carriage.
- Each bobbin is held between pintles with suitable interlock for pintles. Individual wires constant tension can be controlled through mechanically or electronically-brake tension.
- Heavy-duty enclosed gear box or external gearbox at the rear end of each carriages having provision driving the carriages in anti-clockwise or clockwise direction.
- Single Capstan with fleet ring or haul off caterpillar for constant pull and lay, pneumatic / hydraulic braking system for each carriage.
- Synchronization can be done through line shaft or with fully automation control of the whole line through digital drives and PLC, MMI or SKADA, etc.
Technical specifications of the Armoring Machines without Back Twist are as follows
- Nos. Of Bobbin in a Carriage 24/36/48/54/72
- Diameter of Bobbin as per DIN 400 / 450 / 500mm
- Diameter of Wire GI strip 4.0x0.8mm / GI round 0.7-3.5mm
- Cable Diameter 20mm to 120mm
- Centre Wire Pay Off Drum Size 1250-2500mm
- Carriage RPM 125 / 100 / 75 / 50 / 30
- Take Up Drum Size 1250-3000mm