Machinery and spares offers different kinds of press brake. Being a part of that sew hydraulic press brake of hpb series are manufactured for fabrication operations which demand accuracy, quality & productivity in their forming requirements. Salient features are as follows:
1. sturdy welded frame is designed for maximum resistance to deflection
2. torsion bar is designed for beam stability & parallelism
3. cylinder [y1 & y2] are manufactured from high quality steel and designed to maximum seal interfaces, load concentration and wear points
4. high quality low friction pressure seals are used
5. front operated power adjustment depth setting. It is equipped by mechanical depth stops by precision gear box transmission.
6. precision mechanical stops provide repeatability of the beam movement to facilitate consistent bending results
7. manifold hydraulic block is designed with highly efficient valves to provide, low noise and smooth reversal system
8. selectors switch for foot, hand, auto, inch operation controls
9. ram is of one piece construction and is guided with long adjustable gibes, ground finished and fitted with non-metallic liners
10. bed is of welded construction with precisely hand scrapped table top surface
11. piston rods are hard chromed and grounded for smooth and trouble free performance
12. three speed bending operation includes last free fall, stable bending and rapid return to facilitate good production cycle times
13. simple switch point control of ram front free fall to bending speed is adjustable
14. adjustable tonnage control with readout from zero to full tonnage enables operator to set the required tonnage
15. holding time of zero to five seconds allows better bending resul
