Gullco internatioanl limited welding positioners improve productivity and weld rotary ground and turntables complete with mounting flange for self-centring gripper. It has tilt mechanisms andmicroprocessor based pulse width modulation motor controls. Welding positioners increase efficiency for any project as the microprocessor motor control enables operator interface of start, stop, clockwise rotation, neutral, counter clock-wise rotation and infinitely variable control of the speed within the model. To make production on long work pieces easier and faster a 2.5 inch "through hole" model is also available. Table tilt is manually set at any desired angle from 0 to 90 degrees quickly and easily. Gullco internatioanl limited offers a wide variety of accessories that allow the positioner to be expanded into a fully automated pipe welding/cutting system. Various footswitch models are available including variable speed footswitch for manual operation. When activated, the footswitch will provide a run signal to the control and allow regulation of the rotational speed via the compression of the footswitch pedal. Various free standing support and welding gun or torch holder assemblies are also offered for further automation and increased productivity. Safety is greatly enhanced with gullco`s low [24v] control and power supply system.