Uni-automation offers supplies an abrasive cut-off machine abrasive cut-off machine with equipped with completely automatic operation for to facilitate precision cutting of copper, steel, alloy steel, brass, steel, alloy steel or non-metallic materials in cross sections range of up to 40 x 40 mm. Multiple rods or profiles can also be fed through the machines holding and feeding device. The abrasive cut-off machine can be fitted with a a thin abrasive wheel of 1 to 2 mm thickness to achieve can be used and cutting length accuracies of ±0.07 mm can be achieved. The and the perpendicularity of 0.05° is achievablepossible. The abrasive cut-off machine from uni-automation machine runsoperates in automatic mode with a plc and with cycle time between 7 to 30 seconds depending uponin the basis of the cross section of job. The abrasive cut-off machine can perform up up to 4,000 cuts can be taken per shift without requiring no operator control required. When a given length of rod is finished, the abrasive cut-off machine machine stops automatically and flash a lamp mounted [alongwith an optional buzzer] so that the operator can feed a new rod. The abrasive cut-off machinemachine from uni-automation is furnishedsupplied with a feeder conveyor to support the raw material rods. Sensors of the abrasive cut-off machine are rugged sturdy and easy to maintainuser-friendly. Air supply of 5 kg/cm² is required. Cutting feed rate of the abrasive cut-off machine can be fine controlled tuned while fast retract is possible. Transparent machine cover is given provided to restrictlimit dust dispersal. If required, the cooling cooling facility can be provided if requiredincorporated with the abrasive cut-off machine.
