Product Profile of High Frequency Cold Plasma/ Corona Ozone Generator
High Frequency Cold Plasma/ Corona Ozone Generator is highly efficient and used for various application requiring ozone supply. The Ozone Generator is based on MOSFET/ IGBT breakthrough technology that has been applied to the device allowing it to operate from a 230 Volt AC that is easily available. The Ozone Generator is designed with safety interlock switches which remain off at the high voltage power supply, when the door is opened. High Frequency Cold Plasma/ Corona Ozone Generator is manufactured using quality grade raw material which ensures optimum durability along with long lasting trouble free service.
Key Features of High Frequency Cold Plasma/ Corona Ozone Generator
- Highly efficient
- Fused quartz crystal tube
- High frequency cold plasma/ cold corona ozone generator utilizing the state of art Inverter based on MOSFET/ IGBT. Breakthrough technology has been applied to the OG250 allowing it to operate from a 230 Volt AC that is easily available
- Comes complete with a built-in air pump, quartz glass ozone cell and power supply, gas termination
- A true 5/25 Grams per hour cold corona/ cold plasma ozone generator used for various application requiring ozone supply
- Easy to operate
- Simply connect the power cord of the Ozone Generator to a 230 Volt AC socket and switch on the supply
- The Status Lamp will flash at regular interval indicating that ozone generator is ready
- Now rotate the rotary switch ozone on to on position
- The operating frequency is around 6 kHz, which gives maximum ozone output for particular cell design
- The complete circuit is protected for short circuit and over voltage
- The Over temperature protection works for the electronic component and ozone cells
- A powerful and fast micro controller controls the entire operation including protection, and no operator attention is required
- As safety interlock switches off the high voltage power supply, when the door is opened
- The High voltage is generated with a high quality ferrite core transformer
- The transformer is designed to take 25% extra load if required
- The primary and secondary are wound with electrolytic grade copper wire to minimize the copper and skin losses
- The transformer is enclosed in powder coated sheet metal tank and it is oil cooled for high efficiency
- The oil cooling also offers protection to high voltage coil from moisture and dust
- The Ozone cells are fabricated from high-grade stainless steel (316), which offers good resistance to ozone
- The dielectric used is 99.99 % pure quartz glass which has excellent dielectric properties
- The heat loss is also minimum at designed power
- The ends of electrode are sealed with silicone rubber O rings, which is again ozone resistance
- All the pipe terminations are machined out of stainless steel Grade 316, and piping is made of silicon/ Teflon/ plastics material
- The ozone cells are air cooled by three heavy-duty fans, and keep the cell temperature below ozone destruction
- Have two air pumps which are diaphragm type and rated for continuous duty. The pump delivers about 16 litres of air per minute at a pressure of 10.5 PSI. If higher ozone out put is required then feed gas can be oxygen, which will increase the ozone output