Jasmer machine tools offers hydraulic milling machines. The base of heavy rigid casting serve also as coolant tank. It provides a suitable platform for robust operation. The column is again of rigid built. Traces are hand scraped and lapped/ground. The heavy knee is made as a box and rests on a vertical column quipped with thrust bearing and protected from dirt and chips by telescopic covers. The moveable parts inside are protected from foreign matter and coolant, the knee being closed at the upper end. All the hand wheels are relatable. The automatic feeds in all three directions are limited by means of adjustable feed trip dogs. The worktable is of a very sturdy construction and the dovetail is provided with an adjustable jib. The table has three t-slots and is provided with coolant channels. In the construction of the universal milling machine special importance is attached to sturdy construction of the base of the table. The working pressure of the table lead screw is taken up through pressure thrust bearing. The power drive is through an electric motor flange mounted at the rear of the machine. Clutch levers are placed within reach on both sides of the column. The driving shaft and spindle shaft are bedded in roller and ball bearings respectively.
