Product Profile of Sinewave Inverter with VA Rating 500VA to 3KVA

Sinewave Inverter with VA Rating 500VA to 3KVA is manufactured by Indiatronics. Sinewave inverter is PIC 16F72 microcontroller based design with pure sinewave output using H bridge topology.

Indiatronics supplies different types of Inverters.

The salient features of Sinewave Inverter with VA Rating 500VA to 3KVA are as follows:

• 110V to 295V mains voltage window or computer compatible voltage window180V to 270V close loop regulated inverter output

• Relay changeover near zero current/zero voltage. & Synchronized change over

• Over current of MOSFETs protected within micro seconds with processor reset.

• Can accept any input waves like sine wave, generator waves etc. If voltage & frequency is within limit.

• In built PFC controlled charger using same mosfets with charging current selectable from 100mamps to 20 amps. Electricity saving compared TRIAC, SCR and capacitor charging. Full charge cut selection mode for Tubular and Automotive batteries.

• Mixed load compatibility for even fridge and motor.

• Overload 2min delay with warning by buzzer and LED up to 130% of rated capacity and 5times auto restart after trip. 400% overload surge capacity to take cold start of fridge, motor etc.


Technical Specifications of Sinewave Inverter with VA Rating 500VA to 3KVA are:

• VA Rating: 500VA to 3KVA

• Input range: 180V to 270V for UPS mode and 100V to 300V for inverter

• Input frequency range: 40 to 60 HZ

• Inverter output frequency: 49 to 51 HZ

• Output waveform: PWM pure Sine

• Output voltage in inverter: 220V +/-5V

• Inverter efficiency: more than 85%

• Power factor: 0.8

• Harmonic Distortion: less than 5%

• Switching frequency: 5KHZ inverter and 10KHZ for charger

• Typical transfer time: 2 ms to sense and give signal to relay