Product Profile of Autogas Box for Atomic Absorption Spectroscopy
Spectrochem Instruments Pvt. Ltd offers Autogas Box for Atomic Absorption Spectroscopy. Spectrochem Instruments Pvt. Ltd also design, develop and manufacture various types of embedded system. The Autogas Box for Atomic Absorption Spectroscopy has safety interlocks for all input gases. The Autogas Box for Atomic Absorption Spectroscopy has microcontrollers. This Box has on board DC-DC converter with single 24v supply. This Box has optically isolated solenoid driver circuit. This Box has 16 X 2 alpha numeric LCD and stand alone front panel operation
Key Features of Autogas Box for Atomic Absorption Spectroscopy
- Have dynamic fuel/oxidant mixing [optional]
- Have Auto ignition, sputter or hot filament
- Have emergency shut down in Nitrous flame if.
- Have automatic mode setting with burner type
- Have Flame sensor
- Have service diagnostic routines for field test
- Have Gas leak sensor [optional]
Product Specification of Autogas Box for Atomic Absorption Spectroscopy
- Sensor:In line gas pressure : Pre-settable NC/NO type pressure switch
Drain Sensor : Float sensor, Drain empty when no minimum water level
Burner Sensor : Dual limit switches for Burner type recognition
Flame sensor : Pre-settable, background light, pilot flame & main flame recognition
- Microcontrollers:Dual microcontroller for extended safety
a) ATMEGA16 Host controller
b) ATTINY2313 AUX system safety controller
- Serial Ports:Dual Full duplex for PC interface & AUX
- Display:16X2 alphanumeric display
- Keyboard:four buttons
- Memory:IIC EEPROM AT24C08 1KB for proportional solenoid orifice control settings
- Connector:SCREW terminal WAGO connectors
- Power Supply:24V @ 5 Amps Input, on board DC-DC converter provides the required system 5 Volt DC
- Solenoids:Normally closed : All SS 316 24 Volt for Ignition, Acetylene, Boost & Nitrous circuits
Normally open : All SS 316 24 Volt for Air circuit