Product Profile of Waterproofing Foam Concrete Plant

Waterproofing foam concrete plant comes with integrated system of mixer, foam generator and pump, working together. Foam concrete plant can be pumped to cast foam concrete walls or poured in block moulds. Waterproofing foam concrete plant can also be laid on terrace and other floors to get benefit of thermal and acoustic insulation, with all the other benefits of foam concrete.

Key Features of Waterproofing Foam Concrete Plant

• Discharge pipe is connected at the end of this chamber and the discharged foam concrete can be poured in the moulds or site as the case may be
• Inlet pipe with a strainer provided with the plant has to be just put in the barrel containing diluted foaming agent
• Diluted liquid is automatically pumped into the system and with compressed air the foam is generated
• Can be taken from the bypass line provided and ensured that it has the required parameters before it is changed to supply in the system.
• Cement slurry is sucked and discharged into a chamber where the foam generated is also pumped into this chamber
• Foam is injected into the cement slurry while it pass through the chamber
• Can be pumped to cast foam concrete walls or poured in block moulds
• Comes with integrated system of Mixer, Foam generator and Pump, working together
• Can also be laid on terrace and other floors to get benefit of thermal and acoustic insulation, with all the other benefits of foam concrete
• Very good replacement as screed for surface preparation for water proofing and other such allied jobs
• Density of the foam concrete can be adjusted easily by just turning a knob
• Requires just 40 sq ft of area and requires just 06 HP (SA-40) of power
• Can be very easily operated with just ONE operator by pressing buttons in the Control Panel, and unskilled labour to load the raw material
• Takes just 01-02 minutes to discharge one batch of foam concrete after the material is loaded in the plants mixer
• No other operation to be done till the ready foam concrete is poured in the moulds / site at a distance of 250 mtrs from the plant, and 30 mtrs in height
• In the mixer section, cement sand / Flyash and water are charged as per the mix design established for the required density