Product Profile of Industrial Grade Drilling Hammer
Industrial grade drilling hammer has 2 inch long flat wrench. Drilling hammer comes with chuck, bit retaining ring, ‘o’ ring b. R. R., bushing,‘o’ ring bushing, wear sleeve, piston and control tube. Industrial grade drilling hammer also equipped with choke, make – up ring, air distributor, spring, check valve plunger, check valve cap, back head and ‘o’ ring back head.
Key Features of Industrial Grade Drilling Hammer
- Comes with Chuck, Bit Retaining Ring, ‘O’ Ring B. R. R., Bushing,‘O’ Ring Bushing, Wear Sleeve, Piston and Control Tube
- 2 inch long flat wrench
- Equipped with Choke, Make – Up Ring, Air Distributor, Spring, Check Valve Plunger, Check Valve Cap, Back Head and ‘O’ Ring Back Head
Product Specification of Industrial Grade Drilling Hammer
- Back Head Thread:3.5 inch API /3 inch BECO 27/8 API IF PIN
- Wrench Flat:3.5 inch API /3 inch BECO 27/8 API IF PIN
- Total Length of Hammer:1127 mm
- Total Weight of Hamme:103.5 Kg
- Recommended Compressor:150 – 350 PSI, 540 – 1350 CFM
- Outside Diameter of Hammer:148 / 142 mm
- Penetration Rate:70 – 100 ft / hr
- Drilling Range:152.4 mm – 229 mm
