Product Profile of SSR Analog DC to AC Power Controller
Union Controls Pvt Ltd supplies SSR Analog DC to AC Power Controller. Union Controls Pvt Ltd is approved by EN-60947-5-1. SSR Analog DC to AC Power Controller is available with heat sink and Din rail mounting. SSR Analog DC to AC Power Controller offers inbuilt snubber network.
Key Features of SSR Analog DC to AC Power Controller
- The Load power is proportional to the Controller input
- Output to body 4 Kv -isolation
- Heat sink and Din rail mounting [35mm]
- Inbuilt snubber network
- Controlled range 10% to 90% of the Line voltage
- Linearity better than &# 177 2 % of the range.
- 4-20mA Phase Angle Controller - Star With Neutral Delta
- ON-OFF Type of SSR
- 3Phase Motor ON-OFF
- 3Phase Motor Forward & Reversed
- DC to DC Power MOSFET
- Clutch & Brake
- Hot Runner System
- Vibration Unit by Pot
- Impulse Sealing of Heater
- Burst Full Cycle Switching
- Selection of SSR for Capacitor load
- Wrong connection
Product Specification of SSR Analog DC to AC Power Controller
- Ambient Temperature:-30...+80°C
- Impedance:100 ohm, 300 ohm
- Maximum Barrier Layer Temperature:125°C
- Output Circuit - Switching Element:THYRISTOR
- Peak Inverse Range:1000Vpk
- Power Factor:>0.5 (at 600VAC)
- Test voltage Between all isolated circuits:4kVA
- Wire Size:O/p.16sqmm(max.),I/p. 4sqmm(max.) ( For Electric Connection )
