Product Profile of Revolving Centre With Four Bearings
Revolving Centre with Four Bearings is mainly designed for conventional slow speed lathes. The Revolving Centre features point that is made from bearing steel and hardened to approximately 60 HRC for maximum wear resistance. The Revolving Centre is provided with plain, carbide tipped and extended points type bearings. Revolving Centre with Four Bearings has all centres sealed for entry of coolant and swarf or chips by special sealing arrangement.
Key Features of Revolving Centre With Four Bearings
- All centres are sealed for entry of coolant and swarf or chips by special sealing arrangement
- Each centre provided with an inspection report covering all critical parameters like run out, correctness of Morse Taper angle etc.
- Precision ground
- Maximum radial run out within 0.015mm.
- Body made alloy steel case hardened and tempered to a hardness of 32 - 40 HRc approx.
- Point made from bearing steel and hardened to 60 HRC approx. for maximum wear resistance
- Used for conventional slow speed lathes
- Closer run outs can be provided on requirement
