Product Profile of Horizontal/ Vertical Designed Thermic Fluid Heater

Horizontal/ Vertical Designed Thermic Fluid Heater is fully automatic in nature. Horizontal/ Vertical Designed Thermic Fluid Heater is available in three and four pass design. Unitherm Engineers is the manufacturer of Horizontal/ Vertical Designed Thermic Fluid Heater.

Unitherm Engineers also manufactures diverse types of fired heaters like steam boilers, thermic fluid heaters, pressurized & non pressurized hot water generators, direct fired hot air generators etc. Horizontal/ Vertical Designed Thermic Fluid Heater can obtain temperature up to 2800 C /3000 C with low operating pressures.

Horizontal/ Vertical Designed Thermic Fluid Heater has the following features:

• Fully automatic operation

• Three & Four Pass design, Maximum Fuel efficiency.

• Multiple passes on Thermic fluid side ensure low-pressure drop across the coil, thereby making more head available for the process.

• Can obtain temperature up to 2800 C /3000 C with low operating pressures.

• Low System lag, rapid warm up response,

• High Thermic fluid volume in the coil ensures adequate thermal storage and low heat flux.

• Higher heat transfer area provided in the coil ensure low thermal stresses on the tube surface, and result in longer life of the coil as well as the Thermic oil.

• Coil is made out of Boiler Quality, B.S.3059, 9 Gauge, TATA/TI make, ERW tubes for longer life and high temperature operation.

• Designed with hinged doors for easy access on all sides of shell. Inspection doors are provided at strategic locations for easy inspection, Cleaning & Maintenance of Coil.

• For solid fuel firing External bottom furnace with large combustion volume & high grate area is provided, which can easily burn most low-grade solid fuels like high ash Coal, lignite, Briquettes, wood, etc,

• For solid fuel firing specially designed, heat resistant fire bars made from close-grained cast iron give long operational life.

• Specially designed expansion & balancing tanks are provided to avoid overheating of Thermic oil and releases excess pressure & vapors and ensure longer life of Thermic fluid.

• For solid fuel firing, No direct impingement of flame on to the coil due to external furnace, hence no overheating or charring of Thermic oil, thereby increasing operational life.

• For solid fuel firing, by pass Chimney is provided with damper to safeguard against overheating and Charring of oil in case of power failure.

• Outside the purview of I.B.R.

• Completely safe operation with a number of safety features and instrumentation provided