Product Profile of Photovoltaic Cell Module Laminator with Vacuum Pump

Hind High Vacuum Co. [P] Ltd manufactures Photovoltaic Cell Module Laminator with Vacuum Pump. Hind High Vacuum Co. [P] Ltd is an ISO 9001:2000 recognized company. Photovoltaic Cell Module Laminator with Vacuum Pump is available in various models, designed to encapsulate interconnected photovoltaic solar cells and interconnecting wire to protect them from atmospheric humidity, dust, wind & other mechanical stresses.

Photovoltaic Cell Module Laminator with Vacuum Pump has the following features:
Simultaneous and Independent read out of Vacuum Temperature

• Uniform platen Temperature and power distribution from 3 phase power control.

• Minimum temperature over-shoot due to PID and Thyristor phase angle controller.

• Continuous monitoring of platen heaters health by current monitoring of individual heaters circuits.

• Over temperature protection in case of control instrument failure to protect the platen temperature.

• Guaranteed Vacuum soak and lamination temperature before start of curing.

• Complete lamination, cure and cooling in one cycle. AUTO/MANUAL, mode selection with switch.

• Laminates variety of modules

• Pressure diaphragm evacuation and venting are independently controlled.

• Fast cooling cycles through large surface area water cooled heat exchanger.

• Advanced Engineering and selection of the material provides clamp free sealing of vacuum chambers.

• High capacity double stage vacuum pump provides fast vacuum cycles