TPS Technoplus Services offers Boiler Combustion Control. TPSTechnoplus Services is a full service process engineering and consulting organization offering a wide range of services in Boiler and Heater Consultation, steam and hot oil piping system, heat recovery system, energy audit and instrumentation. The Boiler Combustion Control, FBC requires an output of Steam pressure, furnace pressure and O2 sensor. The Boiler Combustion Control FBC has 13 steps Look up Table which can be used to program the non-linear output with a single pre-programmed and configured controller.
The Boiler Combustion Control, FBC has automatic Combustion Control with Manual Fuel/Air Ratio adjustment. The boiler control loop receives the drum pressure signal from the drum pressure transmitter and compares it to the operator-entered setpoint. The controller modulates its output in order to eliminate any difference between the signal and the set point. The output of the controller represents the boiler demand for steam, and is sent to the variable speed drives on the feeders or distributors if automatic feed control is used. It is also sent to the fuel/air ratio station. The operator may adjust the setpoint in automatic or place the controller in manual to fire the boiler manually. The controller rejects to Manual on bad signal quality. A high/low pressure alarm is shown.
