Product Profile of Pump Pressure Control System with Flow Sensor
Pump Pressure Control System with Flow Sensor maintains constant pressure with Frequency of 50 / 60 Hz and can be fitted to any kind of pump. Hitech Systems manufactures Pump Pressure Control System with Flow Sensor. Hitech Systems offers a wide range of Pumps, Presses and Motors for various industrial applications. The Pump Pressure Control System of model number PWM 400 D 13.3 has two sets of Pressure Selection that can be programmed and can operate in 2 different pressures when required.
Key Features of Pump Pressure Control System with Flow Sensor
- Water hammering is avoided as the motor rpm is reduced considering the flow.
- Float switch Optional
- Increases Pump life by more than 30%
- Easy to install
- Up to 60 % Power Saving
- With inbuilt flow sensor dry running protection is accurate and it will stop the pump immediately and will try again after 10 minutes.
- Daily Unlock [If the pump is not used for 24 Hours it automatically starts and runs for a few seconds]
- Malfunctioning of Pressure - If in case of failure of pressure sensor the system stops [in other systems it works at the maximum pressure causing damages to the booster systems].
- Intelligent Over Heating - It reduces the output current in case of extraordinary high temperature of the electronics without stopping the device. [In other systems the whole system is stopped].
- For Booster sets no special cable is required.
- Control Panel is not required.
- Float Switch is not required.
- External Devices not required.
- Easy to setup.[ the procedure for setting up is very less whereas in other systems more time is taken]
- Digital Display for all the settings.
- 3 Menu Programming
Product Specification of Pump Pressure Control System with Flow Sensor
- Application:Commercial buildings and Industries, Fire Fighting
- Current:Max. 13.3 (A)
- HP Range:7.5
- Model:PWM 400 D 13.3
- Pressure:Max. 16
- Voltage:I/P: 3 x 400, O/P 3 x 400
