Product Profile of Pump Pressure Control System with Dry-Run Protection
Pump Pressure Control System with Dry-Run Protection has two sets of Pressure point Selection that can be programmed and can operate in 2 different pressures when required. Hitech Systems offers Pump Pressure Control System with Dry-Run Protection. Hitech Systems supplies a wide range of Pumps, Presses and Motors for various industrial applications. The Pump Pressure Control System with Dry-Run Protection maintains Constant Pressure at Frequency 50 / 60 Hz and can be fitted to any kind of pump.
Key Features of Pump Pressure Control System with Dry-Run Protection
- Water hammering is avoided as the motor rpm is reduced considering the flow.
- Float switch Optional
- Increases Pump life by more than 30%
- Easy to install
- Up to 60 % Power Saving
- With inbuilt flow sensor dry running protection is accurate and it will stop the pump immediately and will try again after 10 minutes.
- Daily Unlock [If the pump is not used for 24 Hours it automatically starts and runs for a few seconds]
- Malfunctioning of Pressure - If in case of failure of pressure sensor the system stops [in other systems it works at the maximum pressure causing damages to the booster systems].
- Intelligent Over Heating - It reduces the output current in case of extraordinary high temperature of the electronics without stopping the device. [In other systems the whole system is stopped].
- For Booster sets no special cable is required.
- Control Panel is not required.
- Float Switch is not required.
- External Devices not required.
- Easy to setup.[ the procedure for setting up is very less whereas in other systems more time is taken]
- Digital Display for all the settings.
- 3 Menu Programming.
Product Specification of Pump Pressure Control System with Dry-Run Protection
- Application:Hotels, Commercial buildings and Industries
- Current:Max. 4.7 (A)
- HP Range:1.5
- Model:PWM 230 3-Basic 4.7
- Pressure:Max. 16
- Voltage:I/P: 1 x 230, O/P 3 x 230
