Product Profile of Rapid Type Mixer Granulator

Rapid Type Mixer Granulator cannot be started unless fluid bed trolley is kept underneath discharge assembly. The Granulator has belts, pulleys and transmission system which are adequately guarded with suitable covers. The Granulator can`t be started if the air pressure is below the set value. The Rapid Type Mixer Granulator can be availed with mechanical seals to enable vacuum loading of material.

Key Features of Rapid Type Mixer Granulator

• Belts, pulleys and transmission system are adequately guarded with suitable covers.
• Can`t be started if the top lid is open due to a proximity sensor.
• Can`t be started if the discharge flange is open for cleaning due to a proximity
• If main impeller is lifted upward fir cleaning or for visual inspection during validation of cleaning. The machine can`t be switched on.
• Can`t be started unless fluid bed trolley is kept underneath discharge assembly.
• Main impeller can be lifted by hydraulic cylinder by 100 mm during washing. Using this feature main impeller gets lifted up by a hydraulic cylinder by actuating an electric switch so that cleaning and visual inspection for validation process for the main impeller cleaning can be done easily.
• Automation of RMG operation by means of programmable logic controller.
• CIP wash system or clean in process system can be supplied which can be either plc or manual depending upon the requirement.
• Machine with mechanical seals to enable vacuum loading of material.
• Jacketed vessel for heating/ cooling. Solvent recovery can be done by a separate condenser
• Main drive can be made to run on hydraulic motor so that main impeller rpm can be varied infinitely.
• Dry mixing: 2 to 4 minutes
• Wet granulation: 4 to 15 minutes.
• Discharge: 30 to 60 seconds
• Complete cycle: 6 to 20 minutes.