Key Features of Double Cone Blender

• The conical shape at both ends enables uniform mixing and easy discharge.
• All contact parts are made out of stainless 304 or 316 quality material, as required by customer.
• Maximum care has been taken to ensure safe operation of the unit.
• Manual rotating facility with hand wheel for inching. The same will be provided with ss cover & limit switch. [ In 200 Kgs. & above model ]
• Two nos. of safety road will be provided at back side. [ One LH side & one RH side ]
• Suitable size of butter fly valve at one end of the cone provided for material discharge & hole with openable cover provided at other end of the cone for material charging & cleaning.
• One shaft with 04 nos. of fixed buffels with mirror polished provided inside the cone.
• Cone will be mirror polished from the inside & outside & structure will be matt polished.
• All moving parts covered with SS304 covers.
• Safety guards made from SS304 pipes provided in front of the m/c with limit switch.
• Panel fabricated from SS304 material with facility of three phase indication, D.O.L. tarter, digital timer & Amp. Meter.
• As per customer requirement machine will be provided with left side drive or with right side drive.
• The conical shape at both ends enables uniform mixing and easy discharge.
• All contact parts are made out of SS304/316[as per customer requirement] quality material.
• Maximum care has been taken to ensure safe operation of the unit.
• Worm reduction gear use for speed reduction.
• Food grade rubber gasket will be used on both end of cone as well as in butterfly valve.
• Inside & outside of the cone will be polished to the mirror finished.
• General structure made out of SS304 and Polished to the matt / mirror finish in GMP Model.
• All safety guards & covers made out of SS304 in GMP Model.
• Hand wheel will be provided for manual tilting of cone.
• Safety guards provided with limit switch to not start the machine when safety guards are not in proper position.