Chitra machineries offers colloid mill that is useful for ointment and cosmetics section. The mill is equipped with feeding device to feed the products into the operating area by is subjected to high shearing, cutting and rubbing forces between stator and rotor. The material is forced in to the next tooth stage due to conical arrangement and the centrifugal effect of the rotor rotating at a high speed [2800 rpm]. The tooth vibrations subject the particles with high degree of forces while providing intense whirling multiplying the grinding and mixing effect. The angular gap becomes narrower towards the discharge section due to the slightly deviating tapering of milling surface of the stator and rotor. The drainpipe discharges the processes material continuously through the mill and can re-circulate it if required. Some of the salient features of these colloid mill include ss304 / ss316 / ss316 l quality material made contact parts; coupling between motor shaft and rotor for the easy maintenance; special sealing arrangement between the motor and the processing chamber to prevent liquid going in side the motor winding resulting in the motor burning; modified design of semi concave teeth in rotor & stator gives better performance in size reduction without damaging the product; 3 way cock system for draining and re-circulation of liquids & discharge spout for viscous products as standard; dol starter with overload relay for protection against single phasing and low voltage; easy dismantling of contact parts for cleaning; and flame proof construction on demand[at an extra cost].
