Product Profile of Lymphocyte Chemoattractant Factor Wash Primer
Tuff Coat Polymers Pvt. Ltd. Manufactures Lymphocyte Chemoattractant Factor Wash Primer. Tuff Coat Polymers Pvt. Ltd. Is an ISO 9001:2008 awarded company. The company manufactures Quality Industrial Paint. The company manufactures products like all type of Synthetic Enamels and Primers, All type of Quick drying paints and primers, Epoxy paints and primers, Polyurethane paints and primers, Chlorinated Rubber paints, Stoving Enamels. The Lymphocyte Chemoattractant Factor Wash Primer is a two-component system [2k system] Base component containing Polyvinyl Butyral resin with anticorrosive pigments which are Lead Chrome Free. Polyvinyl Acetal Resin say Polyvinyl Butyral one gives excellent water resistance through its paraffin structure while dioxin link molecules of six atoms give raise a noticeable chemical resistance.
The key properties of Lymphocyte Chemoattractant Factor Wash Primer are as follows:
- Leas Chrome Free Primer- as per environmental conditions
- Faster drying at room temperature
- It can withstand up to 350° C
- Phosphating can be eliminated from pre-treatment
- For mild rusting, no sand rusting is required as little particle of rust also get converted into mg phosphate ion
- Excellent water resistance
- Adhesion to many substrates like Aluminium, Plastics, Steel, and M. S
- After this priming welding is possible.
Product Specification of Lymphocyte Chemoattractant Factor Wash Primer
- Application Area:By spray, Brush
- Base:Based on PVB Resin with lead chrome free anticorrosive pigments, off white or grey in Colour, having good consistency.
- Density of Mix:0.9 gm/cc
- Drying Time:Touch Dry: 10- 15 minutes
Hard dry: 2 - 3 hours
- Effect under welding:It can be applied on metals, which have Sub-Sequent to be welded. It leaves little ash and will cause no obstruction in the weld. It gives off no obnoxious Fumes of welding
- Film Colour:Off white/ Grey
- Finish:Matt
- Flash Point:Below 22°C.
- Hardener:Very thin & clear with acidic in nature
- Mixing ratio:1: 1 By Volume
- Mixing Viscosity:Around 15 to 25 sec By F/C no. 4 (At 30°C)
- Outside Exposure:It will protect the surface up-to one to six months approximately It is always recommended to apply Top Coat over Was Primer
- Over Coat Interval:After 15 minutes before 6 months
- Recommended DFT:10 – 15 microns per coat.
- Shelf Life:Up to 1 year as long as the sealed containers are kept in dry place
- Temperature Resistance:10 to 350
- Type:Two packs cold or at low temperature curing System
- Toxicity:Only spray vapors are acidic & protection of operator is desirable. It can be controlled by good ventilation. Operator should use mask & goggle while spraying. Mild irritation to skin in wet condition
