Multiple Blades Cross Hatch Cutter has 6 cutting blades spaced either 1mm or 2mm apart. The Cross Hatch Cutter operates on one cutting pass that makes 6 cuts in the coating and a second pass at 90 degree makes a square lattice pattern. The Cross Hatch Cutter has the cutting blades ground on to 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use. The Multiple Blades Cross Hatch Cutter allows application of special adhesive tape over cut section.
Multiple Blades Cross Hatch Cutter is manufactured by Caltech Engineering Services. Caltech Engineering Services also manufactures a wide range of coating thickness gauges, holiday detectors, pinhole detectors, jeep meter, surface profile gauges, wet film thickness gages, pit gauge, Cathodic disbonding tester, bridge-cam-gauge, fillet weld gage, chloride test kit, infrared thermometers and RH/dew point meter. The range of products finds application in Coating Inspection, Cathodic Protection, NACE Corrosion Testing, Welding Inspection etc.
