Integrated technology provides dry lubricant moly bonded coating spray, model it-85 a. This is designed for lubrication of the sliding surfaces operating in dirty/dusty atmospheres. Applications: used successfully for the lubrication of coarse chains and guide ways operating under high loads and exposed to high temperatures; as a lubricant for highly stressed joints with slow sliding speeds and / or oscillating movements. Instructions for use: clean the surface thoroughly, preferably with a solvent. Do not touch the cleaned surface again by bare hands before spraying. If handling is essential, use clean cotton gloves. Shake the can vigorously at-least for a minute [for intermittent use during one operation, shaking for a few seconds is enough]. Spray from a distance of 15 - 20 cm to give a thin, even coating. After use, turn the can upside down and spray till only the propellant gas comes out. This will help clean the dip tube and actuator, thereby avoid choking.
