Fabrotech has introduced a digital event counter/totaliser. The digital event counter is useful as pulse counter in different process and industries. The digital event counter can be used to display the linear measurement such as total length in metres or cm. The input pulse can be from a proximity switch, infrared sensor, voltage pulse or normally open [no] contact of a switch. The event totaliser can be reset by the front switch or from the rear terminal. 6-digit 0.56 height bright red leds display the count. Optionally this 6-digit counter can be used as low cost, compact 11-digit counter. In case of power failure, the display count is retained in memory without any battery [optional]. The power consumption is less than 5 watts. Its operating supply voltage is 230 v ac ±10%, 50 hz. The counter is housed in an enclosure of din size 48 [h] x 96 [w] x 110 [d] mm.
