Product Profile of Chemical & Wear Resistant Electrophoretic Lacquer
Ronuk Industries Ltd manufactures Chemical & Wear Resistant Electrophoretic Lacquer. Ronuk Industries Ltd offers wide ranges of metal cleaner, pickling chemicals, general metal finishing, conversion coatings, lacquers, strippers, antiquing chemicals, basic chemicals etc. Chemical & Wear Resistant Electrophoretic Lacquer is environmentally friendly in nature. This Electrophoretic Lacquer offers rapid processing time.
Key Features of Chemical & Wear Resistant Electrophoretic Lacquer
- Environmentally friendly.
- Low toxicity.
- Low voltage water based process.
- Simple low cost equipment required -low entry cost.
- Long life finishes.
- Superior appearance and even distribution.
- Rapid processing time.
- High volume production from smaller plant.
- Stable process.
- Cathodic process.
- Beautiful colors for new designs & effects
- Non polluting and Safety in use.
- No fire hazard.
- No water or air effluent treatment systems.
- Suitable for external use even in adverse environments.
- No runs, sags, windows.
- Saves energy.
- Occupies less factory space.
- Simple to control and use
- No attack on metal being coated.
- Any conductive substrate can be coated.
- Can replace gold, brass and other costly finishes.
Product Specification of Chemical & Wear Resistant Electrophoretic Lacquer
- Acid Resistance:5% H2SO4 20°C: 300 Hrs. passed
1% H2SO4 20°C: 480 Hrs. passed
- Alkaline Resistance:5% NaOH 20°C: 300 Hrs. passed
5% NaOH 20°C: 480 Hrs. passed
- Corrosion Resistance:Salt spray to ASTM B117
On forged brass: 270 - 600
On forged brass (passivated): 350 - 1000
On cast brass (passivated): 200 Hrs. plus
On zinc die-cast (direct) (passivated): 260 - 550
On mild steel (phospated): 300
On stainless steel (passivated): 300 - 2000 + Hrs. depending on type
On aluminium (Extruded): 2000 Hrs. + (Salt spray tests are discontinued after 20 W Hrs.)
On aluminium (Cast): 2000 Hrs. + (Salt spray tests are discontinued after 20 W Hrs.)
- Pencil Hardness:3 - 5 H (Dependent on cure & substrate)
- Solvent Resistance:Acetone rub test: 30 - 1000 double rubs depending on type and cure
- Test:QUV UVB Test (Moisture & UV): No perceptible change after 500 Hrs. in Appearance coloured or transparent
ASTM 968-51 (Dip Lacquer): 2 - 5
Falling sand test (Spray Lacquer): 2 - 5
Expressed as litres of sand (Porcelain Enamel): 5.3
ANSI perspiration test A 156.2 - 1983 9.7.5: Passed (RONUCLAD H A R P - High Acid Resistance Process.)
- Bending Test:5 mm Ø passed (Bend at 180° on steel bar)
- Impact Resistance Test:Passed 200 g x 2 m (steel ball drop)
- Per Mil Thickness:Acrylic: 18 - 21
Silicone Polyester: 20
Acrylic Film Laminate: 21.5
Flurocarbon Film Laminate: 46
