Product Profile of Electrical Isolated Overspeed/ Underspeed Monitor
Electrical Isolated Overspeed/ Underspeed Monitor is designed with line fault detection facility. The Overspeed/ Underspeed Monitor is a one-channel signal conditioner and requires 24 V DC supply for operation. The Overspeed/ Underspeed Monitor is configurable by keypad and ensures two relay contact outputs. Electrical Isolated Overspeed/ Underspeed Monitor is rigid and durable in construction and comes in application specific design.
Key Features of Electrical Isolated Overspeed/ Underspeed Monitor
- One-channel signal conditioner.
- 24 V DC supply [Power Rail].
- Dry contact or NAMUR inputs.
- Input frequency 1 mHz to 12 kHz.
- 2 relay contact outputs.
- Start-up override.
- Configurable by keypad.
- Line fault detection [LFD].
- Up to SIL2 acc. to IEC 61508.
Product Specification of Electrical Isolated Overspeed/ Underspeed Monitor
- Connections:300 mm fixed cable with M12 x 1, 4-pin connector
- Indicators:Function display : 2 LEDs yellow for switching state
Operating elements: 5-step rotary switch for operating modes selection (threshold setting and operating modes)
Controls : Switch for setting the threshold values
- Interface:Type : IO-Link
Protocol : IO link V1.0
- Lasers:class 2
- Light:red, modulated light
- Light Source:laser diode
typ. service life 85,000 h at Ta = +25 ° C
- Measuring Range:0.2 ... 8 m
- Method:Pulse Ranging Technology (PRT)
- Working Voltage:10 ... 30 V DC / when operating in IO link mode: 18 ... 30 V
- Output:Signal output : 2 Push-pull outputs, short-circuit proof,
reverse polarity protection
- Parameter:MTTFd : 200 a
Mission Time (TM) : 10 A
Diagnostic Coverage (DC) : 0 %
- Protection:IP65
- Spot Diameter:< 10 mm at a distance of 8 m at 20 ° C
- Standards:EN 60947-5-2, IEC 60825-1:2007
- Wave length:660 nm
