Key Features of KU-HT Version Swing Gate Valve

• Metal to Metal to Metal face sealing for material tight shutoff across the gate.
• The top housing is provided with a baffle at the inlet to guide the flow of material towards the centre and not towards the peripheral sealing fitted in the top housing.
• Gate having beveled knife-edge at bottom to cut through standing columns.
• The bottom housing is provided with tapering surfaces to enable material to slide towards the outlet and eliminate the possibility of material retention.
• The swinging movement of the gate is performed by actuation of lever through 60-70°. This enables effortless open and close operation of valve in few seconds.
• The gate does not come out of the housing unlike a slide gate valve. A axle is welded to the gate and the axle operates in a bearing box packed with o-rings so as to make the valve leak tight to the environment.
• The metallic seal is fitted in a groove provided in the top housing. This sealing remains out of the material flow thereby greatly reducing the possibilities of wear.
• The adjustable supporting bolts/supporting ring provides full support to the bottom of the gate in valve closed position.
• Purging holes provided on top housing enables remove material retention, if any, inside the valve.
• Manual
• Electro pneumatic
• Geared motor
• Size: DN 80, DN 100, 150, 200, 250, 300, 350 & 400.
• Mounting holes drilled to suit flanges as per DIN PN10 & ANSI 150# B16.5