Key Features of Aluminum Open Channel Water Control Gates

• Are used to isolate flow within as well as in and out of an open channel.
• These are suitable for seating as well as unseating water head but the height of water in both cases should be less than height of shutter.
• Designed for channel application, breast wall not required.
• Suitable for flow from either direction.
• Self contained frame suitable for grouting within the side walls of the channel on two sides and grouting within the floor of channel on bottom.
• Frame comprising of HDPE shutter side guides encased in aluminum sections.
• Shutter comprising of aluminum shutter plate reinforced by stiffeners of same material.
• Metal to rubber sealing arrangement on three sides.
• Flush bottom closure arrangement.
• Provided with pin and knuckle type stem connecting arrangement to connect the shutter with the spindle.
• Single piece rising spindle to connect the shutter to the gate operating arrangement mounted directly on gate frame.
• Manual lift mechanism to enable a single person to operate gate with effort
• Corrosion resistant material used for increased life.
• Economical and faster erection of fully assembled gate in a single set-up.