Product Profile of Emergency Lighting Electrical Distribution System
Dynomerk Controls manufactures Emergency Lighting Electrical Distribution System. Dynomerk Controls offers wide ranges of regenerative vehicle chassis dynamometer, eddy current dynamometers, stand alone engine test beds, brake inertia dynamometers, instrumentation for engine testing, transmission test rigs, test rigs & host computer controlled software. Emergency Lighting Electrical Distribution System has feeder panels through which power will be supplied to group of equipment.
Key Features of Emergency Lighting Electrical Distribution System
- Lighting & Emergency Lighting Electrical Distribution will be consisting of following features Centralized Distribution panel through which power will be supplied to all the equipment in Engine testing area.
- This panel will be having main isolator of suitable capacity, Energy meter and feeders.
- Feeder panels through which power will be supplied to group of equipment.
- Design and selection of lighting for each cell would be to provide 350 Lux average after 200 hours of operation, measured at 500mm from AFFL.
- Lighting in control corridor would be to provide 350 Lux.
- Lighting in plant room would be 200 Lux.
- Light fitting in the control corridor will be of recessed type and decorative to match the false ceiling.
- All the light fittings shall be provided with electronic ballast to save energy.
- Emergency lighting within the cells, offices and general areas would be by means of self-contained packs providing the appropriate level of lighting with a capacity of not less than 3 hours.
- These fittings shall be provided with each test cell, Control Room & on mezzanine floor
