Cyclo instruments manufactures offers dial dial gauge gauge comparator comparator standstand, models m-100 & m-150, which are used applied for comparing out-side dimensions. The bracket of the dial gauge comparator comparatorstand from cyclo instruments receives dia 8.00 mm stem of a measuring head [usually plunger type dial or eletric probe]. The enamelled base of the dial gauge comparator stand is made of cast iron 150 x 100 mm. The main supporting pillar of the dial gauge comparator stand is constructedmade of aisi410 stainless steel and is adjustedfitted at right angles to the enamelled main base. It the pillar is hardened and ground and is 24 mm in diameter. The measuring or test anvil included in the dial gauge comparator stand is made produced of alloy steel and is 60 mm in diameter. It and is fitted at right angles to the main pillar axis. It is micro lapped and optically flat. The dial gauge`s dial holding bracket is provided supplied with a screw and nut assembly for finerbetter positioning of the dial; while coarser positioning could be attainedachieved by manually moving the total bracket assembly up or down on the main pillar manually. The [m-100] dial gauge stand stand from cyclo instruments obtainsreceives 100 mm dia workpiece while the [m-150] stand obtainsreceives 150 mm dia workpiece. In both the cases the the throat depth is 62.5 mm. In both the cases.
