Product Profile of 48`` Huller With 8 Basket Seperator

Cottor international provides 48" huller with 8 basket separator mounted on eight-basket beater separator in robust construction with simple adjustment having safe operation. The turning the eccentric shaft located on concave maintains the single adjustment and the distance between the fixed knives in concave and rotating knives in the drum. This arrangement is useful for regulating the percentage of seed cutting by the huller. The concave as the safety studs breaks if any non -ferrous foreign material enters the hullers. But this steel safety studs should never be used as this can damage huller and fatal injury to operator. The 48" huller with 8 basket separator comes with salient features like

• Sharp and properly hardened knives are must for good hulling results. Each knife has four cutting edges and can be turned and reversed before discarding. Frequency of changing knives in drum and concave depends very much on moisture contain in seeds and also impurities [girt] in seeds, but if laboratory results shows high oil contains in hulls this should be first place to check.

• The eight basket beater / separator is designed to produce hulls with a minimum oil content by efficiently beating the hulls to remove the fine floury and small particles of meats and oily lint. The machine consists of an eight-chamber beater section mounted above a shaker separator tray.

• The beater section consists of eight spiked rotating cylinders, each, mounted above a stationary perforated metal drawer. The beater lags are securely fastened to the cylinders and are designed to rotate at a progressively faster speed from inlet to discharge, thereby, pulling apart lumps and thoroughly fluffing the hulls as they travel through. The clean hulls are discharged out the end through a specially designed split chute that passes the hulls around the shaker tray to the hull conveyor below.

• The fine meats, with some fine hulls, sift through the perforated metal of the upper screen drawers onto the shaker tray below. The perforated metal of the shaker tray sifts out the fine meats and fine hulls while retaining the coarser product on top of the screen. An air aspiration nozzle allowing the coarse meats to travel on to the finished meats conveyor while the hulls are transported by air to the tailing beater, where further cleaning is provided, and then separates the coarse hull and meats on top of the screen.

• The eight basket beater / separator is built of all - steel welded construction into a strong, rigid unit. The inside screens of the beater are easily inspected and cleaned by simply removing two bolts and pulling each complete drawer out one side. The beater cylinders are easily inspected or replaced by simply removing the top sheet metal cover. The shaker separator tray is constructed for lightness and balance, assuring the user of a smooth operation with minimum vibration.

• The eight basket beater / separator is driven from a motor gear reducer positioned at the rear or inlet end of the beater and rotation is accomplished through a roller chain drive.

• The shaker separator is driven from the electric motor to the main drive shaft. Two eccentrics mounted on this shaft along with counter balanced pulleys move the tray in a smooth, forward - backward motion.