Diamant triumph metallplastic offers solutions to improve productivity. Low friction surface coating reduces stick slip effects. Machine tool slide ways made of metallic material [typically cast iron, steel or bronze] shows an undesirable tendency to seize under high loads and speed as well as on areas of continuation caused by grinding dust, chips or under dry running conditions. Further, such slide partners shows stick slip motion caused by different functional value associated with static and sliding conditions. Periodic sticking followed by jerking marks this motion. Preload feed members or backlash in the feed control may increase this effect. Roller bearing elements are being used to reduce deformation of this feed control members due to static preload. However, because these have only a point or line contact, they can show unfavourable vibration damping behaviour. Recently, american robot manufacturers have coated all bearing surface in robot arms with the aim to eliminate roller bearing. However, the coating can also be used on parts, which have a non-sliding relative motion. For example, a hydrostatic, guide bush worm/tooth rack combination demands precise alignment of worn centre to tooth rack to achieve an optimum hydrostatic gap. In the same manner there is another material diamant dwh application method is same as above and is being used for correction of machining tolerance as well as aligning of various components of machine tools. Other application examples are alignment of bushing without mechanical jig boring, pallet locating pins, and hardened slide ways in place. Many other products are also available for building up and repairing worn out surface [cold welding] such as bearing shaft and spindle, for filling score marks, shrink holes and porous castings.
