Key Features of Moisture Resistant General Purpose Belt

• Belt Width - 500 mm to 1600 mm
• Belt Length - 50 meters to 350 meters in a single Roll Length [ maximum diameter of roll is 2.8 mtrs]
• Carcass Construction - Carcass consists of Dipped Synthetic Reinforced fabric based on nylon / nylon [nn] or polyester / nylon [EP].
• Cover Thickness - Varies from 1mm to 20mm depending on the belt specifications.
• Higher Tensile Strength and Good abrasion resistance: to withstand higher wear rate this helps to carry highly abrasive and sharp materials. The special silica based Synthetic Rubber Formulation ensures a very good cut growth resistance to the cover.
• Low Elongation: Our in house availability of fabric combined state of the art post tension device helps us to restrict the elongation to the required minimum.
• Good Impact resistance: Even though it is highly recommended to use a breaker Ply where the impact of falling material is high, these special weaving techniques employed for fabrics ensure a very good impact resistance for the belt.
• Moisture resistance: The special compounds applied to the edges of the CUT EDGE belts ensure that moisture does not affect the belts in any severe climatic conditions.
• Higher Weft Strength: A very high weft strength much above the specified norms allows a very good splicing including the use of mechanical fasteners.
• Quarries and sandpits [ lump sizes more than 400mm]
• Thermal Power stations [ Coal and Ash]
• Cement Works [ run of Quarry , Cold clinker]
• Fertilizer and Chemical Plants [Non corrosive products]
• Coal Mines [ Ore , Coke Additions]
• Steel Plants [ Ore ,Coke , Additions]
• Paper Mills [Wood , Edge trimmings]
• Salt Works
• Sugar Mills [Beets , Cassettes]
• Glass Works [raw materials , Cullet]