Product Profile of Single Phase DC to AC Solid State Relay
Union Controls Pvt Ltd manufactures Single Phase DC to AC Solid State Relay. Union Controls Pvt Ltd is approved by EN-60947-5-1. Single Phase DC to AC Solid State Relay is used for impulse sealing of heater. Single Phase DC to AC Solid State Relay comes with stamped washer screw which is vibration free, tighten firmly with power lugs. Single Phase DC to AC Solid State Relay is available with input LED indication/ output LED indications.
Key Features of Single Phase DC to AC Solid State Relay
- Ip-20 protection by removable touch -proof housing enclosure
- Surface mount technology
- Screw attached with stamped washer are vibration free, tighten firmly with power lugs
- Power wiring by round lugs / fork lugs /pin lugs or direct wire.
- Up to Isolation 2500 Vrms
- Epoxy coated SSR
- Arceless switching
- Panel Mounted SSR
- Reverse polarity protection
- Random type of SSR available
- Suitable up to 16/25 s.q.mm lugs
- True zero cross over/ virtually free from EMI/RFI
- Output to body 4kv-isolation
- Power factor response up to 0.2
- Input LED Indication/ output LED indications
- 4-20mA Phase Angle Controller - Star With Neutral Delta
- ON-OFF Type of SSR
- 3Phase Motor ON-OFF
- Clutch & Brake
- Hot Runner System
- Vibration Unit by Pot
- Impulse Sealing of Heater
- Burst Full Cycle Switching
- Selection of SSR for Capacitor load
- Wrong connection
- 3Phase Motor Forward & Reversed
- DC to DC Power MOSFET
Product Specification of Single Phase DC to AC Solid State Relay
- Ambient Temperature:-30...+80deg;C
- Break Down Voltage:3.8VDC/1.2VDC
- Critical voltage gradient:350 V/µ, 1500V/µ, 1500V/µ, 1500V/µ, 1500V/µ
- Current Consumption:16mA
- Frequency:45-65Hz
- Maximum Barrier Layer Temperature:125°C
- Maximum leakage current:<5 mArms
- Working Voltage:42-480VAC/690VAC
- Output Circuit - Switching Element:THYRISTOR
- Peak Inverse Range:1200Vpk/1600Vpk
- Power Factor:≥0.5 (at 600VAC)
- Switching Time:1period/1period ( Max Zero Crossover make/ break)
- Test voltage Between all isolated circuits:4kVA
- Thermal Resistance:1.1 JC, 1.0 JC, 0.4 JC, 0.25 JC, 0.1 JC
- Voltage drop in on-state:1.3V, 1.3V, 1.3V, 1.4V, 1.4V
- Wire Size:O/p. 16sqmm (max.), I/p. 4sqmm(max.) ( For Electric Connection)
