Product Profile of High Speed Wire Nail Making Machines
High Speed Wire Nail Making Machines are available in three models namely MWN 50, MWN 80 and MWN 130. These machines are fully automatic. The wire feeding is driven by Rolls/Wedge System which is self locking. The clamping pressure on the wire is adjustable, the wire release is pneumatic. H. Mann Industries supplies High Speed Wire Nail Making Machines.
H. Mann Industries is the manufacturer of fasteners making machines, high speed wire nail making machines, etc. In a High Speed Wire Nail Making Machine, the flywheel is mounted on a support independent from the main crank-shaft which therefore is not affected by stresses produced by the freewheel itself and by the drive belts. The machine is totally covered which exceptionally reduces the noise level.
Key Features of High Speed Wire Nail Making Machines
- Solid main bed bushes increase the bearing surfaces and eliminate deformations; with fluent lubricating oil film ensures long life of bushes.
- Spiral type bevel gears run in continuous lubricating system and need no maintenance and are noiseless.
- The round section hammer slide allows a correct alignment with the connecting rod, a larger support surface and an excellent lubrication; moreover an air circulation system cools the slide`s running guide and keeps dirt away from the slide itself;
- The nails ejector is driven by a cam; so there is no contact between the punch and the ejector;
- The crank shaft and lateral shafts are of high quality steel fully ground and are counter-balanced to extend cutters life;
- Cutters and grippers are adjusted by means of vertically positioned screws operating on the wedges;
- The grippers die box is made up of two slides; the stationary gripper is mounted on the former, the sliding one is mounted on the latter that offers large bearing surfaces. Grippers can be removed from the box without taking the box off from the press. This allows to shorten the down-times;
- The centralised lubrication is partially continuous and partially timer controlled. The oil is contained in a tank. Located in the machine bed and it is filtered both on suction and in delivery.
