Key Features of Modular Terminators

• Conforming to the requirements of IEEE Standard 48-1975, IEC 60502-4 and VDE 0278.
• Typical uses for the 35MTG would be on riser poles either at the substation or on the distribution lines.
• The 35MTG can also be used on the switchgear and transformers.
• The 35MTG series of terminators are designed for use on extruded dielectric cables, and can be applied directly on cables with extruded semi-conductive shield.
• Other types of shields can be addressed with the use of adapters.
• The 35MTG series is designed for aluminum or copper conductors with a diameter range over the insulation of 12.6 mm [0.495"] to 50.2mm [1.975"].
• The 35MTG kit comes complete with the appropriate components to connect ground and seal the termination.
• The comprehensive installation instructions will be supplied with each kit describing the correct cable preparation. The termination is a slip-on product which requires less time and labour skill to install if compared to other types of terminations.
• Voltage [Phase to Phase]: 15 kV, 25 kV, 35[36] kV
• Impulse 1.2 x 50 Wave: 110kV, 150 kV, 200 kV
• Corona Extinction Voltage Level 30 kV @ 3pc. Current Rating is equal to the cable`s rating. Ratings based on IEEE Standard 48 -1975, IEC 60502-4 VDE 0278 and do not reflect maximum withstand levels. For levels that exceed the above, contact your Elastimold representative.